Ball Mill Manufacturer-Henan Bailing Machinery Co.,Ltd

Ball mill is widely used in industrial production of high-fine grinding machine. Maintenance and repair of the ball mill is a regular work, maintenance work will affect the mill rate and the life of the operation, then the process of using the proper maintenance and repair, to introduce the following: ball in the normal production of There is always damage problem, since we can not change the ball is damaged, we will pay attention to some of the normal operating procedures Ball, Now I will tell you that under the ball to the use of the maintenance problems encountered with the ball mill maintenance.
Or would let us say a number of considerations under the ball right, so that we use the errors in the ball mill, so that we can better use the ball:
1, inspected once every half-hour ball main bearing and motor temperatures, generally should not exceed 60 ¡æ. 2, monitor back to the oil return pipe mill without interruption, back to the oil temperature
3, an emergency stop should be immediately notified to the mine and the spiral classifier stop to the mine.
4, after the emergency stop should be moved all the electrical switches are parking spaces.
Mill operation to monitor the problem:
1, inspected once every half hour the main bearings and motor temperature, generally should not exceed 60degree.
2, monitor the oil return pipe back without interruption, back to the oil temperature is 35 -45 degree or less.
3, no abnormal sound ministries in operation.
4, the required time, according to the number of additional ball.
5, no loose bolts cylinder and end caps.
These are the correct ball mill operating rules, but we also know how to repair ball mill method, the first time in the ball mill was immediately replaced broken bad wearing parts, so as not to delay the normal operation of ball mills.
1 ball in the first month after use and continuous operation of a lubricant must be replaced, replace all the oil and clear the time, and thoroughly cleaning of the ball mill, followed by replacement of the lubricant. Mill use in the following six months to make sure that each run a oil change.
2 Ball in the regular monitoring should be used when lubrication of the various lubrication points, including lubrication and oil surface height, the frequency of at least four hours once.
3, ball mill in operation, the main bearing lubrication, shaft, gear must be maintained at a temperature below 55degree, the maximum can not exceed 60degree, otherwise the ball to stop the run, and a detailed examination.
4, Mill during operation to maintain steady, strong vibration-free, no abnormal noise, no abnormal current fluctuation phenomena, such as found in the above problems, you need to conduct timely inspections of the ball and adjust.
5, the daily maintenance of ball mill used to determine the state of fasteners, fastener loosening and wear it the other side should also check whether the combination of oil spills, leaks and whether the existence of the phenomenon of missing mine.
6, ball mill balls used in the wear of stone or steel balls to timely monitoring, the more severe wear replacement as soon as possible.
7, ball mill during operation of any irregularities should be immediately for inspection. Mill use is common in industrial enterprises, as one high-fine grinding machine, ball mill work higher strength, greater the chance of wear and tear occurs.
Repair and maintenance of ball mill is a day of work, work directly determine the effect of the operation efficiency of ball mill, ball mill in order to discover the problems and security risks, Office of the normal routine maintenance but also be appropriate Regular parking day, a full inspection of the ball and determine the overhaul plan.
If your ball in the course of any problems caused Welcome Braun Machinery Co., Ltd. Henan, Braun machine will free you warm ball in the production process to answer the problems solution. Braun Welcome to the machine.