1.Process equipment installation of ball mill
Equipment, equipment inspection and acceptance approach → → → bolt construction to prepare the burial place → Equipment → horn of the base (base housing) → install → bolt hole water bearing, main bearing install → large gear ring, the material cover and cylinder assembly → shaft and pinion gear installation → micro → cylinder liner installed, and out of the Department of lining material installed → gear cover, expected out, feeder and platform, and other accessories → Installation of electrical control equipment installation → → Load Debug single load test.
2.ball mill installation
the notes of ball mill:
(1) mill installation of bearing on the quality of the normal operation of equipment and safety. Therefore, the whole installation process must be full-time under the guidance of technical staff.
(2) during the installation process should pay attention to personal safety equipment, special attention when installing the liner, to prevent biased towards the rotating cylinder.
(3) all with the surface of the friction surface should be carefully cleaned before installation, with a surface to inject light oil, dry friction surface to be coated with oil.
(4) After installation, connect the power ball mill, we should strictly control requirements and operating rules can not be free to activate the mill operation.
(5) empty load and load testing to ensure continuous. And the test of time as possible.
(6) In addition to install the technical requirements of installation and use instructions, and should refer to the installation drawings outside the "mechanical equipment installation and construction specifications" in the technical requirements
